IndustryPack, QEMU and LinuxCon
IndustryPack drivers for Linux
In the past months we have been working at Igalia to give Linux support to IndustryPack devices.
IndustryPack modules are small boards (“mezzanine”) that are attached to a carrier board, which serves as a bridge between them and the host bus (PCI, VME, …). We wrote the drivers for the TEWS TPCI200 PCI carrier and the GE IP-OCTAL-232 module.
The drivers are available in latest Linux release (3.6 as of this writing) but if you want the bleeding-edge version you can get it from here (make sure to use the staging-next branch).
IndustryPack emulation for QEMU
Along with Samuel’s work on the kernel driver, I have been working to add emulation of the aformentioned IndustryPack devices to QEMU.
The work consists on three parts:
- TPCI200, the bridge between PCI and IndustryPack.
- The IndustryPack bus.
- IPOCTAL-232, an IndustryPack module with eight RS-232 serial ports.
I decided to split the emulation like this to be as close as possible to how the hardware works and to make it easier to reuse the code to implement other IndustryPack devices.
The emulation is functional and can be used with the existing Linux driver. Just make sure to enable CONFIG_IPACK_BUS, CONFIG_BOARD_TPCI200 and CONFIG_SERIAL_IPOCTAL in the kernel configuration.
I submitted the code to QEMU, but it hasn’t been integrated yet, so if you want to test it you’ll need to patch it yourself: get the QEMU source code and apply the TPCI200 patch and the IP-Octal 232 patch. Those patches have been tested with QEMU 1.2.0.
And here’s how you run QEMU with support for these devices:
$ qemu -device tpci200 -device ipoctal
The IP-Octal board implements eight RS-232 serial ports. Each one of those can be redirected to a character device in the host using the functionality provided by QEMU. The ‘serial0‘ to ‘serial7‘ parameters can be used to specify each one of the redirections.
$ qemu -device tpci200 -device ipoctal,serial0=pty
With this, the first serial port of the IP-Octal board (‘/dev/ipoctal.0.0.0‘ on the guest) will be redirected to a newly-allocated pty on the host.
Having virtual hardware allows us to test and debug the Linux driver more easily.
In November I’ll be in Barcelona with the rest of the Igalia OS team for LinuxCon Europe and the KVM Forum. I will be talking about how to use QEMU to improve the robustness of device drivers and speed up their development..
See you in Barcelona!
Use this link to trackback from your own site.